The Invention

The main part of the house was a Russian stove, preparing food in it, basking in it and dried clothing. Also in the Russian oven cooked Hawk animals. Russian stove taking up most of home served as storage of heat, not letting the temperature vary greatly within the premises. Russian stove is installed directly on the floor, under which were placed wooden poles. In order that would relieve the beam, bottom of the furnace was made of brevna. pipe was not straight up, as part of the pipe after the attic relied on the girder.

Modern technology differ somewhat, for a place in Russian stove is installed gas boiler and heating homes is water batteries. It is also now distributed various other manufacturing technology of the walls. After the invention of various non-natural materials, a large number of synthetic insulations. One such bad material is impermeable to heat the foam. The most simple technology for manufacturing such a house – it is House from the panels. The panel – two sheets of particle board and between the foam sheet.

This home certainly will not breathe a frame house, but it will be pretty good to keep warm. Also on the environmental characteristics, he is much worse than the wooden house. With time of the foam become prominent and various harmful artificial substances that will enter the home. In any case, their influence will be detrimental. Log wooden house opposite a very good breathing and does not emit harmful to living materials. There are also other similar technologies panel houses, which sandwiched between two layers of wood are placed various heat-saving materials. Such materials may be – concrete block, opilkobeton, Mineral wool, glass, etc. A particular type of construction technology storey houses are glyaninye home. These homes also are environmentally friendly and energy-saving "for the construction of adobe homes first construct a wooden frame of logs. Then, over the roof frame is made and this roof is covered with roofing material. Thereafter prepared a liquid solution of clay and straw kneaded with him and placed in a cage. By frame moves movable formwork. Walls of the house and pressed gradually turns a monolithic wall. After this you should dosushit walls and you can do oshtukaturku. You can sheathe the exterior wall siding, can be plastered. Inside, you can also make a plaster or plasterboard wall covering. This house gets energy-efficient, since the thermal conductivity of the walls as thick as 60 cm is obtained eight times lower than the thermal conductivity of the same wall made of silica brick. Compared with a wooden log house a home is also superior to its energy efficiency. But perhaps it is less dolgovechen.Interesna technology also framed houses, but the filling does not straw, and geokarom. Geokar a new insulation material fabricated by compaction of peat-straw mixture. In addition he has a very low thermal conductivity, it also does not rot. That ended our mini review different technologies storey building of rural homes. Principle the choice to you and think of what kind of house you live too. One tip, if you want to live long and be healthy by various cancers, look at construction of as many natural materials. Let it be sand, wood, peat, straw and less use of various materials obtained by chemical and petroleum refining.